Tue

22

Jul

2014

SMD soldering youtube tutorial

Read More 2 Comments

Sun

06

Apr

2014

Youtube video about how to solder

Here is an video about how to solder properly!

Read More 1 Comments

Tue

24

Dec

2013

How to choose the right soldering station or soldering iron

There's a lot of sorts of soldering irons. For the majority of initiatives, you'll need a soldering station having 30 w or even more. An under-powered iron is often a terrible purchase. It finds itself costing you much more in wrecked products and damaged parts.

 

It will take lengthier to heat the joint, permitting heat to propagate to the part getting soldered - often times overheating and harming the component. Much longer heating times may also give more time for oxides to form around the surfaces being soldered. This prevents the solder from flowing and produce a poor joint.

 

Longer recovery times between joints can result in frustration, 'cold joints' or both. You don't need to spend a fortune to get a good iron. Advanced features such as temperature control and interchangeable tips are nice to have, but not essential for hobbiest-level work.

 

If you want to check more info on how to pick up a soldering station. You can check out this review site.

1 Comments

Wed

09

Oct

2013

How to do soldering safely

soldering tip
soldering tip

A typical less expensive soldering pencil of 25 W or fewer is ok. A temperature-controlled solder station is more preferable however! I recommend good Hakko solder. The common use of lead-free solder has been implemented. It is very difficult to work with. Any small can of flux is necessary to have and lasts a while. Cheap pin nose pliers, angledflush cutting pliers and wire strippers can also be necessary for printed circuit board assembly. It happens to be from time to time important to unsolder a component, for this reason copper braid plus a solder sucker are great additions to the list. 

 

Scorching irons/pencil and hot solder burns… hence don’t wave the iron around, lean on it or leave it unattended! In addition keep in mind that the cable of the soldering iron could be easily melted and damaged. The gases released when soldering really should not be breathed in. heAlthough they have little lead (not incredibly hot sufficient to vaporize very much) the gases are damaging. Any time clipping leads use caution because they can fly an unexpected range, so put on glasses or basic safety goggles.

0 Comments

Sun

15

Sep

2013

Semiconductor the industry that I have been working in II

Semiconductor the industry that I have been working in II
Semiconductor the industry that I have been working in II

Based on the pattern and demand semiconductors are classified into six major types and they are Standard devices-this type of semiconductor were used in a wide variety of ways, Exclusive devices-these are chiefly the similar to other standardized devices however they only differ with the devices as they have technological monopoly on the particular semiconductors and thus can only be produced by a couple of producers.

 

Specific devices: these are also heap produced but can only be used in a definite way, Custom devices: these are produced for a definite user and according to the user requisites, Microprocessors-they are produced in mass, but are programmed for specific purposes only, Semicustom devices- certain parts of these types of semiconductors are produced mass and are arranged according to the necessities of the user.

 

The impact of the semiconductor industry on the business world and on our day by day life has been the greatest. It went through enormously fast development. Its research and production development is among the expensive ones. This industry will probably be the main industries of the future.

 

The previous post is here.

0 Comments